goKit Deployment Mode

Note: Deployment Mode

• The goKit Deployment mode allows users to connect to the goKit and pull down applications and frequency sets.  This is useful for offline deployment 

• The goKit cannot simultaneously be connected to WiFi and in Deployment mode

 To enter Deployment Mode:

1. Select "Deploy"
2. Select a frequency set that has been saved for offline use, or from the goKit group created in the Pro Portal (if online), or create a new frequency set
3. Select Mission Pack (if applicable)
4. Choose if use only permissions should be applied (service user or standard user privileges)
5. Choose if the goKit should deploy as a WiFI hotspot which supports Applications, Mission Packs, and Frequency Sets, or as a QR code which support only Frequency Sets

Troubleshooting

Problem 1: How do I pull an application from the goKit?

Solution:

    1.  Enter Deployment mode from the Kit

    2.   From the End User Device, connect to the Wi-Fi SSID displayed on the goKit Screen

1. To download apps to an End User Device Navigate to a web browser
2. In the browser navigate to an uncached website (a website you have not visited on this EUD)
3. Choose from the list of stored applications to download
4. Follow installation steps on screen  

Problem 2: My goKit WiFi hotspot is providing intermittent signal to users

Solution: It is recommended to have several users access the kit at a time as the hotspot can get bogged down if too many users are pulling from the kit at once

• The kit can be taken out of deployment mode and then put back in deployment mode to re-initiate the WiFi hotspot